Triton RT2000 X2 Installation Manual - Manual (Page 22)

22
M
ODEL
RT2000 (X2) I
NSTALLATION
G
UIDE
4. Connect the ground wire attached to the bill tray to the ground stud located on the inside left of the
VOHHYH FDELQHW VKRZQ LQ ¿JXUH DW ULJKW 6HFXUH ZLWK WKH ZLQJQXW SUHVHQW
5. Next, connect the power cable to the LED circuit board as shown below.
Secure ground wire.
Power cable (located in harness). Secure ground wire.
Ground wire shipped with control panel trim.
6. :LWK SHUVRQV LQVLGHRXWVLGH VOLGH WKH XQLW EDFN LQVLGH XQWLO WKH
FRQWURO SDQHO WULP LV ÀXVK ZLWK WKH RXWVLGH ZDOO
7. Before securing/anchoring the cabinet, check to ensure the control
SDQHO WULP LV ÀXVK DJDLQVW WKH H[WHULRU ZDOO 0LQRU DGMXVWPHQWV FDQ
be made using the cabinet leveling feet.
8. 6HFXUHDQFKRU WKH FDELQHW WR WKH ÀRRU RU SOLQWK LI XVHG &DELQHWWULP
installation is complete.