Triton 9100 Installation Manual - Manual (Page 35)

A-5
A
PPENDIX
A - S
OFTWARE
L
ICENSE
A
GREEMENT
/ C
OMPLIANCE
/E
MISSION
S
TATEMENTS
Notification of Changes in Telephone Company Equipment: The telephone company may make changes in
its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this
happens, the telephone company will provide advanced notice in order for you to make necessary
modifications to maintain uninterrupted service.
Repairs and Returns: If telecom compatibility trouble is experienced with the Model 9100 ATM, you may
contact for repairs and warranty information: Triton at 1-228-868-1317
Triton Systems of Delaware, Inc.
522 East Railroad Street
Long Beach, MS 39560
If the equipment is causing harm to the network, the telephone company may request that you disconnect
the equipment until the problem is resolved. Repairs should be made only by qualified factory
representatives.
Party Lines: The Model 9100 ATM must not be used on party lines.
Alarm Equipment: The Model 9100 ATM should have its own dedicated phone line. Do not install the 9100
on the same line as alarm equipment.
Electrical Safety Advisory: Telephone companies report that electrical surges, typically lightening transients,
are very destructive to customer equipment connected to AC power sources. This has been identified as a
major nationwide problem. A commercially available, power surge suppressor, is recommended for use with
the Model 9100 to minimize damage in the event of an electrical surge.
C
ANADIAN
IC C
OMPLIANCE
N
OTICE
:
The Industry Canada label identifies certified equipment. This certification means that the equipment meets
telecommunications network protective, operational, and safety requirements as prescribed in the appropri-
ate Terminal Equipment Technical Requirements document(s). The department does not guarantee the
equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection. The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any
repairs or alterations made by the user to this equipment or equipment malfunctions may give the telecom-
munications company cause to request the user to disconnect the equipment.