Triton 9100 Installation Manual - Manual (Page 34)

A-4
M
ODEL
9100 I
NSTALLATION
M
ANUAL
C
OMPLIANCE
/ E
MISSION
S
TATEMENTS
DISCLAIMER
The manufacturer of the Automated Teller Machine (ATM) product(s) described herein makes no
representations or warranties, either expressed or implied, by or with respect to anything in this manual, and
shall not be liable for any implied warranties of fitness for a particular purpose or for any indirect, special, or
consequential damages. Information in this document is subject to change without notice and does not
represent a commitment on the part of the manufacturer.
** CAUTION **
Changes or modifications not expressly approved by Triton Systems
could void the regulatory compliance approval and the warranty.
Use of this product in a manner other than those described in this
manual may result in personal injury!
FCC C
OMPLIANCE
Statement of Compliance: This equipment complies with Part 68 of the FCC rules. Located in the control
area of the ATM is the product label. This label lists the FCC registration number and ringer equivalence
number of the unit. If requested, this information must be provided to the telephone company. USOC/FIC
Codes: When ordering service from the telephone company for the Model 9100 ATM, the following
information should be supplied:
Universal Service Order Code (USOC): RJ-11C
The Facility Interface Code (FIC): 02LS2
Plug and Jack: The plug and jack used to connect this equipment to premise wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by ACTA. A compliant
telephone cord and modular plug is provided with this product. The telephone cord is designed to be
connected to a compatible modular jack that is also compliant.
Ringer Equivalent Number (REN): The REN is used to determine the number of the devices that may be
connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in
response to an incoming call. In most but not all areas, the sum of the RENs should not exceed five (5). To
be certain of the number devices that may be connected to a line, as determined by the local RENs, contact
the local telephone company.
Harm to the Network: If the Model 9100 ATM causes harm to the telephone network, the telephone
company will notify the customer that a temporary discontinuous of service may be required. If advanced
notice is not possible, the telephone company will notify the customer as soon as possible. You will be
advised of your right to file a complaint with the FCC if you believe it’s necessary.