Triton 9100 Installation Manual User Manual

Page 13

NSTALLATION

ROCEDURES

7. Use the silver key to unlock both the control panel and the

fascia door (which conceals the locking mechanism) on the
front of the cabinet. Open the fascia door.

8. Lift the handle under the bill chute to open the front enclosure

door. If the door is locked, see the sidebar on this page for
help in unlocking the electronic or mechanical lock, if
applicable..

9. Remove the packing material from inside the vault enclosure.

Next, carefully remove the dispensing mechanism (TDM-
100/SDD, if applicable). Inspect the dispenser and report
any damage to Triton. Set the mechanism aside, if applicable.
This will be installed in later steps.

10. The accessory box is shipped inside the cabinet enclosure.

Open and inspect the contents. Check the contents against
the enclosed packing list and report any missing parts to
Triton.

UNLOCKING

COMBINATION LOCKS

Mechanical Lock. There are two
marks on the dial ring. The index mark
at the top of the dial is used for open-
ing the lock. A revolution is counted
each time the selected number is
aligned with the opening index.
Locks are shipped on a factory set-
ting of ‘50’. To unlock, turn the dial
to the left (counterclockwise) FOUR
(4) turns, stopping on ‘50’. Then turn
the dial to the right (clockwise) until
the bolt is retracted.

Electronic Lock. The combination of
the lock is preset to 1-2-3-4-5-6. To
unlock, enter the preset combination
and check for proper operation. After
each keypress, the lock will ‘beep’.
After the final digit has been entered,
the lock will beep twice, and the open
period begins. When a valid combi-
nation has been entered, the operator
will have approximately 3 seconds to
open the lock. To open the lock, turn
the outer ring of the dial clockwise.
After the lock is opened, the vault
door may be opened.

NOTE

The Model 9100 ATM is designed
for indoor use only!