Triton 9100 Installation Manual - Manual (Page 16)

16
M
ODEL
9100 I
NSTALLATION
M
ANUAL
Install Chemical Anchors
Bolt Plinth to Floor
1. Move the ATM into position for mounting by aligning the base over the four holes drilled in the
previous procedure.
2. Begin by inserting a Chem Stud capsule into one of the mounting holes. Either end of the capsule may
be inserted first.
3. Place a washer and a nut (in that order) onto a chisel point rod. Thread the nut onto the rod, leaving 3
to 4 threads exposed.
4. Thread the rod coupler onto the threaded rod until it is tight against the nut. The threaded rod used
should be free of dirt, grease, oil or other foreign material.
5. Select the drive unit, insert it into a rotary hammer drill and engage the coupling to be used.
Insert Chem Stud capsule in mounting hole.
Prepare chisel point anchor rod.
Add washer and nut.
4. Place a flat washer on the anchor bolt followed by a 1/2” nut.
5. Repeat Steps 2 and 3 for the remaining anchor bolts.
6. Ensure the cabinet is as level as possible given the floor conditions. Use a bubble level to verify this.
If a bubble-level is not available, the cabinet can be “rocked” gently from front-to-back and side-to-
side to check the need for leveling.
7. Use a torque wrench and 3/4” socket to tighten each nut to a torque setting of 60 foot-pounds
(required to establish the maximum pull-out strength of the anchors). If a torque wrench is not
available, use a ratchet wrench and 3/4” socket to tighten the nuts three full turns beyond hand tight.
8 Once the nuts are tightened as specified in Step 7, install a second nut on each bolt and tighten down
firmly.