Triton 9100 Installation Manual - Manual (Page 26)

26
M
ODEL
9100 I
NSTALLATION
M
ANUAL
M
INIMECH
I
NSTALLATION
Power switch on right side of
power module.
1. Unlock and open the control panel. Verify that the power
switch is in the OFF (0) position. Close the control panel.
2. Unpack and remove the mechanism from its shipping
container.
4. Place the dispenser on the tray. Turn the dispenser so that
the rear of the unit (where the power and data cables
connectors are located) may be accessed.
3. Remove the packing material from the ends of the dispenser
data and power cables that are hanging inside the cabinet.
6. Refer to Figure above. Route the power and data cable up through the access hole in the dispenser
tray. If not already installed, clip the strain-relief grommet on to the two cables. Squeeze the release
button on the side of the grommet and push the grommet up and into the cutout hole in the tray. The
grommet should snap into place.
5. Refer to Figure below. Ensure the data cables are connected and secured tightly to the Electronic
Journal, as shown.