Triton 9100 Installation Manual - Manual (Page 21)

21
I
NSTALLATION
P
ROCEDURES
5. If the turntable is not in the service position, pull down on the turntable locking pin located on the
underside of the tray, as shown below, and rotate the turntable ‘clockwise’ until it is in the service
position. Release the locking pin to lock the turntable.
6. Place the dispensing mechanism on the turntable in the cassette service position (with the opening for
the currency and reject cassettes facing to the front as you look into the security cabinet).
7. Refer to figure above. Align the four holes in the base of the dispensing mechanism with the four holes
in the turntable. Secure the dispensing mechanism to the turntable with the four, #6-32 x 5/16 screws
supplied.
Dispenser in
“Operate” position.
8. Reinstall the note and reject cassette. Rotate the dispenser
back ‘counterclockwise’ to the “Operate” position.