SnowEx PWX-250 - Manual (Page 7)

7 © Trynex International 2012 (REV A) F50766
Installation Instructions
Connecting to the Spreader’s Control Module
Cut the Zip Tie holding the Orange and Green Wires.
Remove the Cord that connects to the Spinner Drive:
Detach the wires to the Spinner Power Cord from the studs on the Control Board.
Remove the Harness.
Step 7:
Step 8:
Note: it is optional to remove the
Spinner Harness for the installation. It
only makes it easier to tighten the PWX
Harness Cord Restraint.
Wire Cutters...
7/16” Nut Driver...
Channellocks...
1-1/4 Wrench...