SnowEx PWX-250 - Manual (Page 6)

© Trynex International 2012 (REV A) F50766 6
Installation Instructions
Connecting to the Spreader’s Control Module
Put Spinner Drive into ‘Down’ position.
Unplug the Spreader from all of the plugs on the Bumper.
Remove Spinner Drive Latch Pin.
Remove the Auger Extension Cover.
Push out the lower Plug in the rearward-side of the Control Box.
Remove the Cover of the Power Box.
This kit must be installed by your Snowex Dealer.
Set all parts aside as they are removed.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
5/16” Nut Runner...
Drill...
Long Screwdriver...