SnowEx PWX-250 - Manual (Page 11)

11 © Trynex International 2012 (REV A) F50766
Installation Instructions
Installing on the Spreader
Use parts from the Tank Mounting Kit. Install a Rubber Grommet [D5602] into each of the two holes in the front of
the Frame. The holes are on the side and in line with the ends of the Tanks.
Slide the 3/4” ID Hose [D6990] through the Grommet on the driver’s side of the vehicle (use warm soapy water
to make it easy). Slide onto the Hose Barb on the end of the driver’s side tank (at the bottom). Put a Large Plastic
Clamp [F50577] over the hose and hose barb. Tighten. Repeat for Passenger Side tank.
Step 5:
Step 6:
Channellocks