SnowEx TLR-175 - Manual

Trailer Mount Parts Breakdown
Model #TLR-175
. y t Q n o it p i r c s e D . o N t r a P y e K
D 4116 1/2'' - 13 x 1-1/2'' Hex bolt 2
2 s t u n k c o L - ' ' 2 / 1 0 2 1 4 D
3 p il c n i p r i a H 5 3 1 4 D
D 4136 5/8'' x 5 -1/2'' Hitch pin 1
1 e u g n o t r e li a r T 8 3 4 6 D
1 e m a rf ” A “ r e li a r T 9 3 4 6 D
D 6440 Receiver tube mount 1
2 e ri t r e li a r T 1 4 4 6 D
D 6442 5/8'' - 13 x 7'' Hex bolt special 2
D 6443 5/8'' Flat washers 4
MAXIMUM LOAD WEIGHT NOT TO EXCEED 240 LBS. GROSS
TRAILER MOUNT ASSEMBLY INSTRUCTIONS
Step 1: Insert axle through wheel and axle weldment.
Step 2: Put washer on, then install hair pin clip to secure axle. Repeat Steps 1 and 2 for other side.
Step 3: Bolt tube support on axle weldment.
Step 4: Insert trailer tongue per drawing and pin into position.
Step 5: Insert spreader mount into opposite side of trailer tongue and pin into position.