LT Security LTN7600 Series NVR (V2.2.3) - Manual (Page 18)

User Manual of DS-9600/8600/7700/7600 Series NVR
18
8 INFO Button Reserved.
9 VOIP Button Same as the MAIN/SPOT/ZOOM- button on front panel.
10 MENU Button Same as the MENU/WIPER button on front panel.
11 PREV Button Same as the PREV/FOCUS- button on front panel.
12 DIRECTION/ENTER
Buttons
Same as the DIRECTION/ENTER buttons on front panel.
13 PTZ Button Same as the PTZ/IRIS- button on front panel.
14 ESC Button Same as the ESC button on front panel.
15 RESERVED Reserved for future usage.
16 F1 Button Same as the F1/LIGHT button on front panel.
17 PTZControl Buttons Buttons to adjust the iris, focus and zoom of a PTZ camera.
18 F2 Button Same as the F2/AUX button on front panel.
Troubleshooting Remote Control:
Note: Make sure you have installed batteries properly in the remote control. And you have to aim
the remote control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot.
Steps:
1. Go to Menu > Settings > General > More Settings by operating the front control panel or the
mouse.
2. Check and remember NVR ID#. The default ID# is 255. This ID# is valid for all the IR
remote controls.
3. Press the DEV button on the remote control.
4. Enter the NVR ID# you set in step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the
Status indicator does not turn blue and there is still no response from the remote, please check the
following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
If the remote still can’t function properly, please change a remote and try again, or contact the
device provider.