Configuring general settings, 1 configuring general settings – LT Security LTN7600 Series NVR (V2.2.3) User Manual
Page 141
User Manual of DS-9600/8600/7700/7600 Series NVR
141
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
LTN7616/LTN7732
LTN7732-P8/LTN7604-P4/LTN7608-P4/LTN7608-P8
Figure 9. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: Working Mode,
NIC Type, IPv4 Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically
obtain an IP address and other network settings from that server.
Note:
For the LTN7732-P8, LTN7604-P4, LTN7608-P4, LTN7608-P8 series NVR, you
need to configure the internal NIC address, so that IP addresses are assigned to the cameras
connected to the PoE or built-in switch interfaces.
Note:
The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click
to save the settings.