Hired-Hand Evolution Series Bird Scale Quick-Start Guide - Manual (Page 3)

Manual No. 4801-3008 Rev 8-08 Evolution Bird Scale Quick Start Manual 2 of 10
1. Warnings
Safety may be jeopardized if the equipment is used in a manner not specified by the
manufacturer. Carefully read and keep the following instructions for future reference.
Warning!
The room temperature where the controller is located must always remain between
32 °F and 104 °F (0 °C to 40 °C). For Indoor use only!
Use adequate ventilation to reduce the risk of overheating controller!
Warning!
Do not spray water on the controller! In order to clean the control, wipe it with a
damp cloth.
Warning!
• Do not perform modifications or wiring with voltage applied!
• Before servicing or cleaning unit, switch power off at service panel and lock the
switch disconnecting means to prevent power from being switched accidentally.
When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
• Keep high voltage (or AC) separate from low voltage wires!
Warning!
Before connecting power to the controller, be sure to check the position of the
voltage selector switch. Improper positioning of this switch will cause system failure.
IMPORTANT!
● Although fuses at the input and outputs of the controller protect its circuits in case
of an overload or overvoltage, we recommend installing an additional protection
device on the controller's supply circuit.
● To avoid exposing the controller to harmful gases or excessive humidity, it is
preferable to install it in a corridor.
● The controller should be opened and inspected once a year for moisture. Proper
care will extend the life of the control.