Hired-Hand System 500 Power Curtain Controller - Manual (Page 4)

System 500™ Power Curtain™ Controller 2
4.Warranty
One Year Limited Warranty
The System-500™ Power Curtain™ Controller is warranted for one year from
date of purchase against electrical and mechanical defects in material and
workmanship. If this unit fails to operate during this period, contact your dealer
for repair or replacement without charge, at the manufacturer's option. Damage
by accident or abuse is not covered by this warranty. This warranty gives you
specific rights which vary from state to state. For claims on this warranty, contact
your dealer.
Warrantor: Hired Hand, 1733 Co Rd 68, Bremen, AL 35033.
5. Installation
5.1. Tools Required
Kit Bag (Included) Screwdriver
Crimping Pliers Volt meter
5.2. Instructions
1. Unpack system, and check that all components are present.
1 System 500 Power Curtain Controller
1 6450-2651 Installation Kit
1 6507-0100 PVR-H Relay Box
1 6450-2652 Fuse Kit
2 or 3 6407-2593 Sensors (depending on model)
1 4801-2972 Manual
2. Hang System-500™ with four screws
3. Make sure all power supplies are disconnected before breaking any wires, or
reaching into the enclosure.
4. Open System 500™, and find all connections.
5. Run sensors out to locations inside the house. (One sensor outside the house with
OSC model.) Be sure that the sensors are in a safe location, free from any
temperature influences (direct sunlight, water, etc.) Use care when securing sensor
wires so that you do not cut the wire, Any short, or break in the wire will cause
improper sensor operation.
6. Connect each sensor to its appropriate terminals inside the enclosure. (See wiring
diagrams in the back of this manual.)
7. Connect wires from stage terminals to the contactor panel, or relay box. See wiring
diagrams for locations of terminals.
8. Hookup three wire connection from System 500™ board to PVR-H. See wiring
diagrams for locations of terminals.