Hired-Hand Mega-Cool: Square Reservoir - Manual (Page 6)

Part No. 4801-5397 Rev. 5-08 Mega-Cool System – Square Reservoir Page 6
Flat Bottom Reservoir Support Brackets
1. Install the Flat Bottom Reservoir Support brackets so the system will be level. Determine the height at which the
bottom of the MegaCool system should be mounted above the ground. Make a mark on each end post to
represent the height.
IMPORTANT: The height of the bottom of the System should be a minimum of 4 to 5 inches above the ground in order
to elevate the pump above ground. Failure to do so may void the motor warranty.
2. Stretch chalk line between marks of end posts and mark all posts of system.
3. For each post of system, align bottom edge of metal support bracket with mark on post. Securely mount metal
support brackets on centers of 4x4" posts, not more than 5 ft. (1.52 m) O. C. (on center). Start with the two center
water tank supports and go outward.
4. Secure metal support brackets to wooden posts with ¼ x 2" Lag screws, or secure metal support brackets to steel
posts with #14 x 1" Hex Head TEK screws.
Front View
Support Brackets
Side View
Support
Bracket
54” between
brackets
(no coupling)
12” between
brackets
(with coupling)
8.1/4” between
brackets
(with Water Tank)
16” between
brackets
(Water tank)
Splice
Splice
Splice
Splice
Water Tank
goes here
4 5/16 ” between
bracket and post