Hired-Hand Mega-Cool: Square Reservoir - Manual (Page 12)

Part No. 4801-5397 Rev. 5-08 Mega-Cool System – Square Reservoir Page 12
6” PAD ONLY:
Assemble Left Hand and Right Hand Top
and Bottom System End Cap Sections
together using ¼-20x1/2" stainless steel
bolts and ¼-20 stainless steel nuts
provided as shown above to the desired
height.
NOTE: Top Section without bottom section
used for 3 ft. high pads.
System End Cap assembly:
Top holes in top section adjust height for 4
ft. pads.
Second set of holes from the 4 ft. holes
adjust height for 5 ft. pads.
Third set of holes from the 4 ft. holes
adjust height for 6 ft. pads.
Bottom set of holes adjust height for 2
meter pads.
Install Caps (0006-5024) in unused bolt
holes.
4 ft. Pads
5 ft. Pads
6 ft. Pads
2 meter Pads
Top Section
Top Section
Bottom Section
Bottom Section
NOTE: Illustration
shows lineup for 5
ft. Pads.
¼-20x1/2"
Stainless
Steel Bolts
¼-20x1/2"
Stainless
Steel Bolts
¼-20
Stainless
Steel Nuts
¼-20
Stainless
Steel Nuts
#10x 1”
TEK Screws
NOTE: Install Caps
(0006-5024) in all
unused bolt holes.
Assemble End Caps
Assemble Top Section to
Inside of System End
Right End Cap
Left End Cap