Hired-Hand Bunsen Jet Brooders: Super-Saver Bunsen Jet (Radiant Brooder with Pilot Ignition) - Manual (Page 6)

Super Saver Bunsen Jet Brooder with SPI 4
All controls are located on the gas valve mounted on top of the brooder canopy. There are three
controls you will use: the control knob, pilot purge button, and the thermostat knob, see illustration
below. The control knob is located on the back side of the gas valve and has three positions: ON,
OFF, and PILOT. The pilot purge button is the spring loaded red button located beside the control
knob. The thermostat knob is located on top of the gas valve, and is adjustable from 1 (Low) to 9
(High).
5. Assembly
5.1. Tools Required
Wire pliers 1/2” wrench
7/16” wrench 11/32” nut driver
Phillips screwdriver Gas leak testing solution
Pipe thread sealing compound
5.2. Support Ring Assembly
1. For support ring assembly, see Figure 2, then follow these steps.
2. Insert one suspension rod through each of the openings in the outside of the support
ring. The suspension rod will slide through the opening until the swaged portion
located on the middle section of the bracket is reached.
Pilot Purge Button
Gas Outlet
To Pilot
Gas Inlet
Thermostat
Control Knob
To Thermocouple
Figure 2
Support Ring Assembly
Support Ring
Suspension Rod
Figure 1
Gas Valve