Hired-Hand Universal Ray Tube Heaters: Air Inlet installation - Manual

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4802-0158 Rev 5-08 Page 1 of 1
WARNING
Disconnect all power to the Tube Heater before Installation!
NOTE: These instructions apply to the type AG1 and AG2 Tube Heaters.
INSTALLATION
If your unit was manufactured before February 2007, use the three self-taping screws to attach the replacement
(TP114) plastic Air-Inlet.
Tube Heaters – Air Inlet installation
!
IMPORTANT!
Locate packing slip and make sure that all listed parts are enclosed. If not, call your Hired-Hand distributor
immediately. Please read and understand all instructions in this manual before assembling the Air Inlet.
Replacement Air Inlet
(TP-114)
Original Air Inlet
(TP-44)
#8-1/2" Self-
tapping screw
(3 places)
Plastic Air Orifice with Screen
(TP-114)
Metal Air Orifice with Screen
(TP-44)