Hired-Hand Super-Savers (Forced Air Heaters) XL: White-Rodgers Ignition Control Module - Manual

White-Rodgers Ignition Control Module
Replacement Kit
for 120vac Super-Saver Heaters
HIRED-HAND, INC. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4802-5086 rev 10-03b Page 1 of 6
FIGURE 1
Ignition Control Modules
DESCRIPTION
This kit is provided to replace damaged ignition control
modules on Hired-Hand’s early model Super-Saver
heaters. The kit includes a replacement Ignition Control
Module and additional wire harnesses necessary to
replace a White Rodgers 50E47-160 model control
module with a UT 1018-500 (HHI Part Number 3591-
1851) replacement module.
The White-Rodgers Ignition Control Module Replacement
Kit is supplied with a UT 1018 module, three precrimped
wire Assemblies and crimp terminals.
When the module kit is received, check for shipping
damage or missing parts.
The NEW 1018 module does not have the PCB mounted
2-pin male connector as shown on the OLD 160 module.
Once the 160 module is removed, the female 2-pin
connector will be cut off and replaced with female crimp
terminals.
Replacement Kit Number
Part Number Model
6450-5250
White Rodgers Ignition Control Module
Replacement Kit
Tools Required
Philips Screwdriver Nut-Driver Set
Flat-Head Screwdriver Needle Nose Pliers
Sta-Con Crimpers Wire Strippers
NOTE
Do Not Use These Wiring Instructions To Replace
Any Other Ignition Control Module Except White
Rodgers Model Number 50E47-160.
DANGER
HAZARDOUS VOLTAGES
Failure To Follow These Instructions May Result in Injury
Or Death!
• Only A Certified Electrician Should Replace the
Ignition Control Module.
• Do Not Clean Or Perform Maintenance Without First
Unplugging The Power Cord And Turning OFF The
Gas Supply.
• Ensure All Cables And Wiring Are Placed And
Secured Before Turning Power And Gas ON.
• Do Not Spray Water Or Other Liquids Directly On Or
Near The Control Module And The Igniter Assembly.
!
OLD 160 Module NEW UT 1018 Module