Hired-Hand Super-Savers (Forced Air Heaters) XL: Vent Limiter Installation Maxitrol 325-5A Gas Pressure Regulators User Manual
Vent limiter installation, Maxitrol 325-5a gas pressure regulators, Tools required
HIRED-HAND, INC.
·
1733 Co Rd 68
·
Bremen, AL 35033
·
Phone 1-800-642-0123
·
Fax 205-287-2000
Vent Limiter Installation
Maxitrol 325-5A Gas Pressure Regulators
Part No. 4801-0147
Tools Required
3/8” Drive Ratchet
11/16” Wrench
Directions
1. Find the brass vent limiter.
2. Be sure that the gas pressure regulator is mounted as shown below. It is important that the face of
the regulator with the vent port is as close to vertical as possible.
High Pressure
Inlet
Low Pressure
Outlet
Vent Port
This end up
3. Clean out the vent port (Located on the top of the regulator.) Be sure that the opening is not
restricted.
4. Thread the brass vent limiter into the vent port, and tighten.
Vent Limiter
Vent Port