Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 12-07 - Manual (Page 14)

Part No. 4801-5169 Rev 12-07 Rollup Curtain System Page 14
6.6 Bottom Drive Pipe Assembly
NOTE: Motor drive will attach to bottom pipe.
The bottom drive pipe is composed of 21 ft. (640 cm) sections that connect together with pop rivets.
1.
Lay bottom pipe sections on the ground end-to-end with the swedged end of one drive pipe section facing
open end of adjacent drivepipe section.
2. Connect drive pipe sections together by sliding the swedged end of one drive pipe section into open end of
adjacent drive pipe section. (NOTE: It might be necessary to take a hammer and straighten out the
dimples which were created when the pipe sections were cut). Attach the sections together by installing
stainless steel pop rivets as shown in diagram above and described below.
3. Pop rivet installation. Drill three 3/16 in. (0.48 cm) diameter holes through pipe joint. Space holes equally
around pipe. Insert pop rivets through these holes to fasten the drive pipe sections together.
Bottom Conduit Pipe
(1060-6004)
1.9" 14 GA(3.34 cm) dia.
Diagram showing completed joint of drive pipe with pop
rivets (third pop rivet not visible in this drawing)
Pop rivet
Open end of pipe
Swedged end of pipe