Elitegroup MD100/MD110 (V1.0) Manual - Manual (Page 39)

32
Using BIOS
User Password
This page helps you install or change a password.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
User Password
User Password : Disabled
Press to return to the main menu setting page.
Save & Exit Setup
Highlight this item and press to save the changes that you have made in the
Setup Utility and exit the Setup Utility. When the Save and Exit dialog box appears,
select [OK] to save and exit, or select [Cancel] to return to the main menu.
Exit Without Saving
Highlight this item and press to discard any changes that you have made in
the Setup Utility and exit the Setup Utility. When the Exit Without Saving dialog
box appears, select [OK] to discard changes and exit, or select [Cancel] to return to
the main menu.
This concludes Chapter 3. Refer to the next chapter for information on the software
supplied with the motherboard.
If you have made settings that you do not want to save, use the “Exit
Without Saving” item and select [OK] to discard any changes you have
made.
Change User Password Press Enter
Install or Change the
password.
User Password
This item indicates whether a user password has been set. If the password has been
installed, Installed displays. If not, Not Installed displays.
Change User Password
You can select this option and press to access the sub menu. You can use the
sub menu to change the user password. This item will show if the Supervisor Password
is set.
mnlk : Move F10: Save ESC: Exit Enter : Select +/-/: Value
F9: Optimized Defaults F1: General Help