Elitegroup MD100/MD110 (V1.0) Manual - Manual (Page 34)

27
Using BIOS
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI
state used for
System Suspend.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type S3 (STR)
Soft-off by PWR-BTTN Instant Off
PWRON After PWR-Fail Power Off
Power On by Ring Disabled
Resume By Lan PME Disabled
Resume By USB (S3) Disabled
Resume By PS2 KB (S3) Disabled
Resume on RTC Alarm Disabled
ACPI Suspend Type
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
Soft-Off By PWR-BTTN
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake Up Alarms. This item lets you install a software power down that is con-
trolled by the power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay 4 Sec, then you
have to hold the power button down for four seconds to cause a software power down.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its operating
status.
Power On by Ring
This system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem. You
must use an ATX power supply in order to use this feature.
Resume By Lan PME
This item specifies whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
Resume By USB (S3)
This item allows users to enable or disable the USB device wakeup funtion from S3/
S4 mode.
Resume By PS2 KB (S3)
This item enable or disable you to allow mouse activity to awaken the system from
power saving mode.
mnlk
: Move F10: Save ESC: Exit Enter : Select +/-/: Value
F9: Optimized Defaults F1: General Help