Key and then push the – Rice Lake Condec UMC600IS User Manual

Page 25

UMC 600IS Installation Manual

3.3.3

Option 3 – Time and Date

The time and date clock is attached to the battery-backed memory (U4) and will continue running when the
indicator is off. A variety of formats for printout are available, and access is provided for adjustments (see
Table 3-13).

NOTE:

Option 3 must be enabled when using the Option 4 auto shutoff feature.

NOTES:

•

Prior to setting the time and date, select the current time for parameter 3.1(either dLS or Std). This
feature selection now allows the operator to increment or decrement the time by one hour when clocks
are changed from dLS to Std. To change the time, access Option 3 using the

TARE

key and then push the

Lb/kg

key to toggle from dLS to Std or vice versa.

•

The display for parameters 3.6 and 3.7 alternates between the parameter selection and the current data
value. This continues until new data is entered via the numeric keys. After keying in new numeric data,
press the

ENTER

key to save the new value. The display will again alternate.

•

Time and date can be directly accessed in normal running mode by pressing both the

and

keys for a

few seconds. This allows the time or date to be changed without using the option switches. To exit, press
the

key.

Figure 3-11. Option 3 Menu

Prompt Display

Interpretation

Notes

Time and date option

Time and date settings can be directly
accessed in normal running mode by
holding down both the

and

keys

for a few seconds. The operator can
then make changes without using
option switches. To exit, press the

key.

OP.3

oFF

Off (time and date disabled)

OP.3

On (time and date enabled)

3.1 Std
dLs

Standard Time
Daylight Savings Time

3.2

12
24

Selects 12- or 24-hour time display

3.3

A
P

AM (A) or PM (P) setting when 12-hour clock is selected

3.4

Un
Ab
on

Selects the location of printed time and date data: under (Un),
above (Ab), or on the same line (On) as weight data.

3.5

LEt
nO

Prints date in letters (LEt) or numbers (nO).
For example: Sept 1, 1999 vs. 09/01/99

3.6

Time. Use numeric keys to enter the time in hours, minutes and
seconds (HHMMSS), then press the

ENTER

key (see Note

below)

The display for parameters 3.6 and
3.7 alternates between the parameter
and the current data value. This
continues until new data is entered
using the numeric keys. After entering
new data, press

ENTER

again to

alternate the display.

3.7

Date. Use numeric keys to enter the date in month, day and
year format (MMDDYY), then press the

ENTER

key (see Note

below)

XXXXXXX

OPTION 5

OPTION 4

OPTION 3

OPTION 2

CALIBR

CONFIG

OPTION 6

OPTION 7

SERIAL

OPTION 1

TYPE

OFF

Off

TIME/DATE

DLS

A–PT

Std.

dLs

POS

DATE

Under

LEt

letter

hh.mm.ss

mm/dd/yy

Above

number