Brocade Virtual ADX Security Guide (Supporting ADX v03.1.00) - Manual (Page 53)

Brocade Virtual ADX Security Guide 41
53-1003250-01
Displaying a list of ACL entries
2
Displaying a list of ACL entries
The show access-list and show ip access-list commands displays ACL entries with line numbers.
Numbered ACLs
To display the contents of numbered ACLs, enter a command such as the following.
Virtual ADX #show access-list 99
Standard IP access list 99
deny host 10.2.4.5
deny host 10.6.7.8
permit any
Syntax: show access-list acl-num | all
Named ACLs
To display the contents of named ACLs, enter a command such as the following.
Virtual ADX #show ip access-list melon
Standard IP access list melon
deny host 10.2.4.5
deny host 10.6.7.8
permit any
Syntax: show ip access-list acl-num | acl-name
Applying an ACLs to interfaces
Configuration examples in “Configuring numbered and named ACLs” on page 27 show the applying
of ACLs to interfaces through the ip access-group command. This section presents additional
information about applying ACLs to interfaces.
Reapplying modified ACLs
If you make an ACL configuration change, you must reapply the ACLs to their interfaces to place the
change into effect.
An ACL configuration change includes any of the following:
• Adding, changing, or removing an ACL or an entry in an ACL
• Changing a PBR policy