Brocade Virtual ADX Security Guide (Supporting ADX v03.1.00) - Manual (Page 156)

144 Brocade Virtual ADX Security Guide
53-1003250-01
SSL debug and troubleshooting commands
6
Syntax: [no] system-max ssl-cert-count num-max-certs
Syntax: [no] system-max ssl-keys num-max-keys
The num-max-certs variable sets the maximum number of SSL certificates.
The num-max-keys variable sets the maximum number of SSL keys.
The minimum, maximum and default values for these settings are determined by the license that is
active on your system. For actual values associated with your license, refer to the Brocade Virtual
ADX Licensing Guide.
Configuring the maximum file size of an SSL certificate
You can configure the maximum file size of an SSL certificate, as shown in the following example.
Virtual ADX(config)#system-max ssl-cert-size 4096
Syntax: [no] system-max ssl-cert-size size
The size variable sets the maximum file size of an SSL certificate.
The minimum, maximum and default values for this setting are determined by the license that is
active on your system. For actual values associated with your license, refer to the Brocade Virtual
ADX Licensing Guide.
SSL debug and troubleshooting commands
This section describes SSL debug and troubleshooting commands.
Displaying SSL information
The following SSL statistics information is available from the BP console within the rconsole mode:
• Connection proxy debug counters
• Connection proxy statistics
• Authentication statistics
• Locally stored SSL certificates
• SSL connection information
• CRL status record
• SSl debug counters
• Locally stored SSL keys
• Information about specific SSL keys
• Details of SSL profiles
• Information about SSL record sizes