Brocade Virtual ADX Security Guide (Supporting ADX v03.1.00) - Manual (Page 172)

160 Brocade Virtual ADX Security Guide
53-1003250-01
Displaying socket information
6
asm dm ssldump max
Use the asm dm ssldump max count command to limit the number of packets logged on the
console.
Syntax: asm dm ssldump max count
The default value is 50.
Displaying socket information
The following socket information is available from the BP console within the rconsole mode.
• Socket detail in open status
• All sockets in open status
• Socket state information
To access the display command that present this information, you must enter the BP console using
the rconsole command as shown in
“Using Rconsole” on page 145.
Displaying socket details in open status
Use the show socket id command in the rconsole mode to display socket detail in open status, as
shown in the following.
Syntax: show socket id HEX
The HEX variable specifies the socket ID number in hexadecimal form of the socket.
Displaying all sockets in open status
Use the show socket list command in the rconsole mode to display all sockets in open status, as
shown in the following.
Syntax: show sock list
Displaying socket state information
Use the show socket state command in the rconsole mode to display socket state information, as
shown in the following.
Virtual ADX1/1# show socket id 0
Sock Peer Local State rx_q_bytes tx_q_byptes
0000 0.0.0.0: 0 10.10.1.100: 443 LISTEN 00000000 00000000
Virtual ADX# rconsole 1 1
Virtual ADX1/1# show sock lis
Sock Peer Local State rx_q_bytes tx_q_byptes
0000 0.0.0.0:0 10.10.6.10: 443 LISTEN 00000000 00000000
0001 10.10.6.50:3832 10.10.6.10: 443 ESTABLISHED 00000000 00000000
0002 192.168.22.1:80 10.10.6.50:3832 SYN_SENT 00000000 00000000