Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 76)

FIGURE 20 Removal and replacement of the cable management comb
Replacing a cable management comb
Complete the following steps to replace the cable management comb.
1. Position and tighten the four (4) screws to secure the cable management comb to the chassis.
2. Arrange the cables along the cable management comb.
3. Replace the chassis door.
Port, application, and encryption blade removal and replacement
This section describes how to remove and replace port, application, and encryption blades. It does not
cover the core (CR) blades or the control processor (CP) blades.
Replacing a cable management comb
76 Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-07