Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 75)

Replacing a chassis door
Complete the following steps to reinstall the door.
1. Align the holes in the door with the ball studs on the chassis.
2. Push the door into place. It will snap onto the studs.
Cable management comb removal and replacement
The Brocade DCX 8510-8 can continue to operate during the replacement of the cable management
comb.
Time and items required
The replacement procedure for the cable management comb takes less than five minutes. A #1 Phillips
screwdriver is required.
Removing a cable management comb
Complete the following steps to remove the cable management comb.
1. Remove the chassis door.
2. Remove the cables from the cable management comb and rearrange the cables around the comb.
3. Unscrew and save the four (4) screws holding the comb to the chassis. Support the comb to prevent
it from falling.
4. Remove the cable management comb.
Replacing a chassis door
Brocade DCX 8510-8 Backbone Hardware Reference Manual 75
53-1002180-07