Brocade 6510 Hardware Reference Manual User Manual
Page 30

Port side LED patterns during normal operation (Continued)
TABLE 1
LED name
LED color
Status of hardware
Recommended action
Ethernet Activity/Link
(green)
No light
There is no link.
Verify that the Ethernet cable is
connected correctly.
Steady green
There is a link.
No action required.
Blinking green
There is link activity (traffic).
No action required.
Optical media port
status(one bi-color LED
for each FC port)
Off
No light or signal carrier on
media interface.
Verify that the transceiver is
installed correctly and that the
cable is connected correctly.
Steady amber
Receiving light or carrier, but
not online.
No action required.
Slow blinking
amber (2 sec)
Disabled (by diagnostics or by
portDisable command).
Verify that the diagnostic tests are
not being run. Reenable the port
using the portEnable command.
Fast blinking
amber (1/2 sec)
Port failure.
Check the management interface
and the error log for details on the
cause of the failure. Contact
Technical Support if necessary.
Steady green
Online.
No action required.
Slow blinking
green (2 sec)
Online but segmented
(loopback cable or
incompatible switch).
No action required.
Fast blinking
green (1/2 sec)
Internal loop-back (diagnostic). No action required.
Flickering green
Online, frames flowing through
port.
No action required.
Nonport side LED patterns during normal operation
TABLE 2
LED name
LED color
Status of hardware
Recommended action
Power supply/fan
assembly status
No light
PS/fan is not receiving power or
is off.
Verify the PS/fan is on and seated and
the power cord is connected to a
functioning power source.
Steady green
PS/fan is operating normally.
No action required.
Flashing green PS/fan is faulty.
Note: When the switch is first
powered on the PS/fan status
LED will show flashing green
until POST has completed.
Try the following:
Check the power cable connection.
Verify that the PS/fan is powered on.
Replace the PS/fan FRU.
Brocade 6510 Operation
30
Brocade 6510 Hardware Reference Manual
53-1002174-08