Brocade 6510 Hardware Reference Manual - Manual (Page 26)

OS Native mode. To re-join the switch to the core fabric, refer to the Access Gateway Administrator's
Guide .
Use the following steps to disable Access Gateway mode using Fabric OS commands. For more
information, refer to the “Enabling and disabling Access Gateway mode” section in the Access
Gateway Administrator's Guide .
1. Enter the switchshow command to verify the switch mode.
• “Access Gateway Mode” displays if the switch is in Access Gateway mode.
• Interopmode “0” or “Native” displays if the switch is in Fabric OS Native mode.
2. Enter switchDisable to disable the switch. Access Gateway mode can only be disabled or enabled
when the switch is in a disabled state.
3. Enter ag --modeDisable to disable Access Gateway mode.
4. Enter the ag --modeshow command to verify that AG mode is disabled.
switch:admin>
ag --modeshow
Access Gateway mode is NOT enabled
Brocade 6510 Installation and Configuration
26 Brocade 6510 Hardware Reference Manual
53-1002174-08