Brocade 6510 Hardware Reference Manual - Manual (Page 29)

1 Power supply/fan assembly #2 status
LED
2 Power supply/fan assembly #1 status
LED
FIGURE 5 LEDs on nonport side of Brocade 6510
LED patterns
Port side LED patterns during normal operation TABLE 1
LED name LED color Status of hardware Recommended action
Power Status
(green)
No light System is off or there is an
internal power supply failure. Verify the system is powered on
(power supply switches to I), the
power cables attached, and your
power source is live.
The unit may be faulty.
Contact your switch service
provider.
Steady green System is on and power
supplies are functioning
properly. No action required.
System Status
(bicolor - amber/green)
No light System is off or there is no
power. Verify the system is on and has
completed booting.
Steady green System is on and functioning
properly. No action required.
Steady amber
(for more than
five seconds) A system fault has occurred.
This LED displays steady
amber during POST, this is
normal and does not indicate a
fault.
Check the failure indicated on the
system console.
Contact your switch service
provider.
Blinking amber Attention is required. A number
of variables can cause this
status including a single power
supply failure, a fan failure, or
one or more environmental
ranges has been exceeded. Check the management interface
and the error log for details on the
cause of status.
Contact your switch service
provider.
Ethernet Speed (green) No light Port speed is 10 Mbps. No action required.
Steady green Port speed is 100 Mbps. No action required.
LED patterns
Brocade 6510 Hardware Reference Manual 29
53-1002174-08