Yokogawa Button Operated DX2000 - Manual (Page 65)

63
IM 04L42B01-02E
Installation and W
iring
Recommended Replacement
Periods for W
orn Parts
Setup Items and
Default V
alues
Connecting to the Monitor
1. Turn OFF the DX and the monitor.
2. Connect the DX and the monitor using an analog RGB cable.
3. Turn ON the power to both the DX and the monitor. The DX screen is displayed
on the monitor.
Note
• When the DX is turned ON, a VGA signal is always output from the VIDEO OUT terminal.
• The monitor screen may flicker if the DX or another instrument is brought close to the
monitor.
• The edge of the screen may drop out depending on the monitor type.
Connecting to the USB Port (/USB1)
The USB port complies with Rev. 1.1.
POWER
CF CARD
USB port
USB port
Rear Front
Connecting to the Ethernet Port
Ethernet port
Indicator
Do not connect an Ethernet cable whose plug does
not comply with FCC specifications. If you do, the
DX may malfunction.
CAUTION
Checking the Connection/Communication Status
You can check the connection status of the Ethernet interface with the indicators that are
located above the Ethernet connector of the DX.
Indicator Connection Status of the Ethernet Interface
Illuminated (green) The Ethernet interface is electrically connected.
Blinking (red) Transmitting data.
Off The Ethernet interface is not electrically connected.
Checking the Connection on the DX Display
• Checking the Connection at the status indication section of the DX display
You can check the connection status of the Ethernet interface on the Ethernet Link
indicator located on the right side of the status display section of the basic setting
mode display. The basic setting menu appears by pressing
MENU to display the
setting menu followed by FUNC for approximately 3 s.
• Checking the Connection Status in the Display Section in the Upper
Right Corner of the Communication Log Display of the DX
You can check the connection status of the Ethernet interface on the Link indicator on
the display section in the upper right corner of the communication log display.
Indicator Connection Status of the Ethernet Interface
Illuminated (green) The Ethernet interface is electrically connected.
Off The Ethernet interface is not electrically connected.
Installation and Wiring