Yokogawa Button Operated DX2000 - Manual (Page 11)

9
IM 04L42B01-02E
DX System Configuration
The DX can be used to configure a system as shown below.
Referenced sections are of the DX2000 User’s Manual.
Referenced pages are of this manual.
Ethernet
USB port*
Alarm output*
Sec 3.5-3.8
Transmitter power supply*
Page 61
PC
DX2000
Recorder Temperature
controller
FAIL/status output*
Sec. 2.9
USB flash memory
Sec. 2.12
Keyboard
Sec. 2.11
Monitor*
Page 62
Measurement
input
Sec. 3.3
Pulse input*
Sec. 3.10
Remote input*
Sec. 7.1
Remote Terminal*
Sec. 2.10
CF card
Page 24
Keys
Communication Interface User’s Manual
EtherNet/IP Communication Interface User’s Manual
PROFIBUS-DP Communication Interface User’s Manual
PLC (programmable
logic controller)
EtherNet/IP †
Serial
communication*
RS-232, RS-422/485, or PROFIBUS-DP* †
PLC
PC
Sec. 2.11
Barcode reader †
*: Option
† : Release number 3 or later
Terminology
• Memory sample
The operation of recording measured data.
• Memory start
The operation of starting memory sampling.
• Memory stop
The operation of stopping memory sampling.
• Display data
The waveform data shown on the DX display. The data recorded at the sampling
interval for the displayed data.
• Event data
Measured data recorded at a sampling interval separate from that of the display data.
Introduction to Functions