Yokogawa Touch Screen GP20 - Manual (Page 20)

18
IM 04L51B01-02EN
GP20 External Dimensions
Unit: mm (approx. inch)
Unless otherwise specified,
tolerance is ±3% (however,
tolerance is ±0.3 mm when
below 10 mm).
*1: With modules
*2: Without modules
(*1)
(*2)
288 (11.34)
196.8 (7.75)
287 (1
1.30)
(8 (0.31)
)
23
(0.91)
MAX 247.2 (9.73)
288 (1
1.34)
288 (11.34)
(8 (0.31)
)
22
(0.87)
GP10 External Dimensions
Unit: mm (approx. inch)
Unless otherwise specified,
tolerance is ±3% (however,
tolerance is ±0.3 mm when
below 10 mm).
*1: With modules
*2: Without modules
(*1)
(*2) 196.8 (7.75)
Max 247.2 (9.73)
144 (5.67)
(8 (0.31)
)
144.9 (5.70)
15
(0.59)
143.6 (5.65)
Installing and Removing I/O Modules
Installing a Module
1. As shown below, insert the module into the GX/GP slot.
2. Push the module in until you hear a click. Then, fasten
the screw at the bottom section of the module.*
Module Latch
* Recommended torque for tightening the screws: 0.6 N•m
Removing a Module
1. Loosen the screw at the bottom section of the module.
2. While pressing down on the latch at the top of the
module, pull the module out.
Channel Names
A channel name consists of a unit number, slot number,
and channel number.
0 1 2 3 4
5 6 7 8 9
Rear GX20/GP20
GX10/GP10
Channel name
0
Unit number
(Fixed)
Slot number
Channel number
I/O modules
0 1 2
Installation and Wiring