Yokogawa EJX440A User Manual
User’s manual, Ejx series brain communication type
Table of contents
Document Outline
- CONTENTS
- 1. INTRODUCTION
- 2. CONDITIONS OF COMMUNICATION LINE
- 3. OPERATION
- 3.1 BT200 Operating Procedures
- 3.2 Setting Parameters Using the
BT200
- 3.2.1 Parameter Usage and Selection
- 3.2.2 Menu Tree
- 3.2.3 Setting Parameters
- (1) Tag No. Setup (C10: TAG NO)
- (2) Calibration Range Setup
- (3) Damping Time Constant Setup (C30: AMP DAMPING)
- (4) Output Mode and Integral Indicator Display Mode Setup (C40: OUTPUT MODE, I20: P DISP MODE)
- (5) Output Signal Low Cut Mode Setup (D10: LOW CUT, D11: LOW CUT MODE)
- (6) Integral Indicator Scale Setup
- (7) Unit Setup for Displayed Temperature (D40: TEMP UNIT)
- (8) Operation Mode Setup (D22: REV OUTPUT)
- (9) Impulse Line Connection Orientation Setup (D15: H/L SWAP)
- (10) CPU Failure Burnout Direction and Hardware Write Protect (D25: BURNOUT)
- (11) Software Write Protect (D55: WRT PROTECT, D56: WRT ENABLE, D57: NEW PASSWORD)
- (12) Output Status Setup when a Hardware Error Occurs (D26: ERROR OUT)
- (13) Bi-directional Flow Measurement Setup (E30: BI DIRE MODE)
- (14) Range Change while Applying Actual Inputs (H10: AUTO P LRV, H11: AUTO P URV)
- (15) Sensor Trim
- (16) Test Output Setup (K10: OUTPUT X %)
- (17) Signal Characterizer
- (18) Process Alarm (G10: P AL MODE, G11: P HI.AL VAL, G12: P LO.AL.VAL)
- (19) Status Output (option code AL)
- (20) Capillary Fill Fluid Density Compensation (E10: T.ZERO CMP, E11: TEMP ZERO)
- (21) Adjustment Information and User Memo Fields (J50: ADJ WHO, J51: ADJ DATE, J52: ADJ LOC, J53: ADJ DESC, M17 to M19: MEMO1 to MEMO3)
- 3.3 Displaying Data Using the BT200
- 4. SELF-DIAGNOSTICS
- 5. PARAMETER SUMMARY
- APPENDIX 1. SAFETY INSTRUMENTED SYSTEMS INSTALLATION
- REVISION RECORD