Yokogawa EJX115A - Manual (Page 87)

<5. Parameter Summary>
5-9
IM 01C25T01-06EN
Function Label Item Contents Default value Handling * 1
SP setup A/G Select Gauge/Abs select for static
pressure
Gauge or Absolute Absolute WD
Atm. Pres Value Conversion coefficient 101.3 kPa WD
SP Apply values Rerange for static pressure “0%, 100%, or Exit” MD
SP Damp Damping time constant for SP 0.00 to 100.00 2.00 s WD
SP H/L Select H/L select for static pressure High or Low High WD
SP Min Span Minimum span for static pressure RD
SP LRV Lower range value for static
pressure
Within measurement range 0.0 MPa WD
SP LSL Lower sensor limit for static
pressure
RD
SP URV *3 Upper range value for static
pressure
Within measurement range WD
SP USL Upper sensor limit for static
pressure
RD
Status Device Status Current operating status R
Status group 1 Device status information for
hardware
Display the hardware error R
Status group 2 Device status information for
hardware
Display the hardware error R
Status group 3 Device status information for
process
Display the process error
(Out of specification)
R
Status group 4 Device status information for
process
Display the process error
(Out of setting range)
R
Status group 5 Device status information for
process
Display the process error
(Alarm)
R
Status group 6 Device status information for data Display the setting error R
Status group 7 Device status information for data Display the setting error R
Status group 8 Device status information for data Display the diagnostic alarm R
Status group 9 Device status information for data Display the diagnostic alarm R
Status group 10
HART 7
Device status information for data Display the simulation mode R
Ext dev status
HART 7
Extended Device Status R
Time Stamp Time Stamp 00:00:00 R
Tag Tag Tag number 8 alphanumerics As specified W
Long tag
HART 7
Long tag Max 32 alphanumerics As specified W
Temperature
compensation
T.Z. Cmp mode Temperature compensation mode Off or On Off W
Temp Zero Zero shift compensation –99.999 to 99.999%/degC 0.000%/degC W
Temperature
sensor
Amp temp Amplifier temperature R
Snsr temp Capsule temperature R
Transfer
function
Xfer fnctn Output mode Linear or Sq root As specified or
Linear
W
Units Unit Pressure, Differential pressure unit As specified or
kPa
W
SP Unit Static pressure unit MPa WD
Temp Unit Temperature unit deg C, deg F, or Kelvin deg C W
Write
protection
menu
Enable wrt 10min Write protection release 8 alphanumerics M
New password User set password for write
protection
8 alphanumerics M
Write protect Write protection indicator Yes or No No R
*1: Handling: R=Read only, W=Read & Write, M=Method, A=Applicable for option code AL, G=Applicable for option code DG6,
D=Applicable for differential pressure transmitters. Do not change these parameters for pressure transmitters.
*2: Max three Burst Messages (Burst Message 1, Burst Message 2, Burst Message 3)
*3: The default value shows MWP (Maximum working pressure) of the capsule.
Since the working pressure limit varies according to the Model, refer to the General Specifications section in each user’s manual.