Watlow Series PD Ethernet Enabled Temperature and Process Controller - Manual (Page 6)

W a t l o w S e r i e s P D
■
4
■
C h a p t e r 2 I n s t a l l a n d W i r e
Mounting the Series PD
Figure 4a — Mounting
1. Push unit in and down to catch rail hook on top of rail.
2. Rotate bottom of unit toward rail.
3. Rail clasp will audibly “snap” into place. If the Series PD does not snap into place, check to
see if the rail is bent.
Removing the Series PD
Figure 4b — Removal
1. Press down on back of the Series PD until the bottom hook clears the rail.
2. Rotate bottom up and away from rail.