Watlow Series TM - Manual (Page 7)

Wa t l o w S e r i e s C • 5 • C h a p t e r 2 I n s t a l l a t i o n
2. Insert the controller into the panel cutout.
3. While pressing the bezel firmly against the panel,
slide the mounting bracket over the back of the con-
troller. Be sure the levers on the mounting bracket
line up with the teeth on the case.
4. Press the bracket up to the back of the panel. The
controller should fit tightly in the panel cutout.
Removing the Panel Mount Square 1/8 DIN
Controller
1. Remove power from the system.
2. Remove all the wiring connections from the back of
the controller.
3. Slide a thin, wide tool (putty knife) under all three
mounting tabs, top then bottom, while pushing for-
ward on the back of the case. Be ready to support
the controller as it slides out of the panel cutout.