Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 5)

5
Installations
1. Wiring to the DIO Connector
• Be sure to remove the DIO Connector
from the GP unit prior to starting wiring.
Failure to do so may cause an electric
shock.
„ Items Required to Wire Connectors
Screwdriver
Recommended type: 1891348-1 Electronics AMP.>
If another manufacturer is used, be sure the
part has the following dimensions:
point depth: 1.5mm [0.06in.]
point width: 2.4mm [0.09in.]
Point shape should be DIN5264A, and meet
Security Standard DN EN60900.
Also, the screwdriver's tip should be flat as
indicated in order to access the narrow hole
of the connector:
„ DIO Cable Specifications
„ Connecting the DIO Cable
(1) Insert a flathead screwdriver, at an angle,
into the tool insertion hole (square-
shaped hole) of the connector.
(2) When inserting the flathead screw driver,
be sure that it is perpendicular to the cen-
ter division wall.
• Make the insertion distance of the flathead
screwdriver approximately 4 mm. Insert-
ing forcefully may break the inside of the
connector and will a cause of contact
defect. Also, do not turn the flathead
screwdriver while the tip is inside of the
tool insertion hole (square-shaped hole).
(3) The adjacent wire insertion hole (round-
shaped hole) will be in an open state.
With the flathead screwdriver still
inserted, insert the wire into the wire
insertion hole (round-shaped hole).
(4) Remove the flathead screwdriver from
the tool insertion hole (square-shaped
hole). The wire insertion hole (round-
shaped hole) will close and the wire will
be secured. In the case of wire removal,
remove the desired wire by inserting a
flathead screwdriver into the correspond-
ing tool insertion hole (square-shaped
hole) following procedures (1) and (2).
(5) Insert the wired DIO connector straight
into the DIO I/F of the LT unit.
• Be sure to strip only the amount of
cover required. If too much cover is
removed, the end wires may short
against each other, or against an elec-
trode, which can create an electric
shock. If not enough cover is removed
the wire cannot carry a charge.
• Do not solder the wire itself. This could
lead to a bad or poor contact.
• Insert each wire completely into its
opening. Failure to do so can lead to a
unit malfunction or short, either against
wire filaments, or against an electrode.
• When wiring, be aware of the
installation position, direction, and
twisting of the wiring as to not develop
stress on the connector. Fix the cable
near the LT by cable clamp and set it
loosely as to not place tension on the
connector.
DIO Cable
Diameter AWG24 to 18
UL1015 or UL1007
Conductor
Type
Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are
not twisted correctly, the end wires may either
short against each other, or against an
electrode.
Conductor
Length
Screwdriver Tip
Shape
7 mm
[0.28in]
Screwdriver
Wire
Wire insertion hole
(Round-shaped hole)
Tool insertion hole
(Square-shaped hole)