Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 4)

4
„ Output Specifications (Source type)
‹Output Circuit (Source type)
• Since the output terminals are not electrically protected, an output line might be short-
circuited or a connection fault might damage the GP unit. Please install an applicable fuse to
prevent an overload in the circuit, if necessary.
Rated Voltage DC 24V
Rated Voltage Range DC 20.4V to DC 28.8V
Output Method Source Output
Maximum Load Voltage 0.2A /point, 0.4A /common
Output Voltage Drop DC 1.5V or less
Output Delay
Time OFF to ON 1ms or less
ON to OFF 1ms or less
Voltage Leakage (when OFF) 0.1mA or less
Clamp Voltage 39V ± 1V
Type of Output Transistor Output
Common Lines 1
Common Design 2 points/1 common line
External Connection 12-pin connector (also used for Input)
Output Protection Type Output is unprotected
Internal Fuse 1.5A, 125V DIP fuse (not replaceable)
Surge Control Circuit Zener diode
Output Points 2
Output Signal Display No LED indicators
Status Display Element None
Isolation Method Photocoupler Isolation
External Power Supply DC 24V
L
L
+24V B1
0V A1
Internal Circuit
Internal Circuit
OUT1 A2
Fuse
1.5A
OUT0 B2
+
-
DC 24V
External Power