Proface AGP3300H - 5.7 Handheld HMIs" - Manual (Page 10)

10
Installation prerequisites for
standards
The GP-3200 Series units are UL/c-UL listed
products.
(UL File No.E220851, UL File No.E210412 )
For the detailed certification's information,
refer to the Pro-face Home page.
Be aware of the following items when
building the GP into an end-use product:
• The GP unit’s rear face is not approved as
an enclosure. When building the GP unit
into an end-use product, be sure to use an
enclosure that satisfies standards as the
end-use product’s overall enclosure.
• The GP unit must be used indoors only.
• Install and operate the GP with its front
panel facing outwards.
• If the GP is mounted so as to cool itself
naturally, be sure to install it in a vertical
panel. Also, it’s recommended that the GP
should be mounted at least 100mm away
from any other adjacent structures or
machine parts. The temperature must be
checked on the final product in which the
GP is installed.
• For use on a flat surface of a Type 1Type
4X (Indoor Use Only) and/or Type 13
Enclosure.
Hazardous Locations -
Compliance and Handling Cautions
(1) Power and input/output wiring must be in
accordance with Class I, Division 2 wir-
ing methods - Article 501.10(B) of the
National Electrical Code, NFPA 70
within the United States, and in accor-
dance with Section 18-152 of the Cana-
dian Electrical Code for units installed
within Canada.
(2) Suitable for use in Class I, Division 2, Groups
A, B, C, and D Hazardous Locations, or
Non-Hazardous Locations only.
(3) “WARNING: Explosion hazard-
substitution of any components may
impair suitability for Class I, Division
2”.
(4) WARNING: Explosion hazard-when in
hazardous locations, turn OFF power
before replacing or wiring modules.
(5) “WARNING: Explosion hazard-do not
disconnect equipment unless power has
been switched off or the area is known to
be Non-Hazardous”.
(6) In the case of use in Hazardous
Locations, be sure to check that the
externally connected unit and each
interface have been fixed with screws
and locked.
In Hazardous Locations, it’s impossible
to insert or pull the cable from the
applicable port. Be sure to check that the
location is Non-Hazardous before
inserting or pulling it.
Product Model No.
UL/c-UL
Registration Model No.
AGP3200-A1-D24 3580205-03
AGP3200-T1-D24
3580205-04