AMX Wireless Touch Panels (Wave Server) - Manual (Page 50)

40 Designing Touch Panel Pages ViewPoint Wireless Touch Panels
• Turn On a VCR and select TV.
• Turn On a satellite receiver.
Pulse command
Figure 50 shows a sample pulse command format and description of the variables.
• Sample
Format
:
$P
• Variables:
number>: This number represents an AXlink device that is associated
with 255 channels. The device number must be 2, 3, or 4.
number>: This number represents one of 255 particular control
functions associated with a device. The channel number
must lie within the range of 1 and 255. For example, a
button programmed on a touch panel with device 3,
channel number 15 would be directly associated with the IR
code programmed at device 3, channel 15. When that
button is pressed, the touch panel transmits the IR code
programmed at device 3, channel 15.
pulse on>: This parameter represents the length of time that the pulse
will remain on. This number is a time in tenths of seconds.
For example, to keep the IR pulse on for 1 second, the
required parameter is 10. The largest number for this
parameter is 65535 or approximately 109 minutes.
after pulse>: This parameter represents the length of time between
pulses. This number is a time in tenths of seconds. For
example, to add a delay between pulses for 10 seconds,
the required parameter is 100. The largest number for this
parameter is 65535 or approximately 109 minutes.
: This character indicates the end of the statement
(carriage return is pressing the RETURN key on the touch
panel keyboard).
• Example :
$P 3 15 10 100
Figure 50
Sample Pulse command
format and variable
description