Progressive International Electronics PIcon II Console - Manual (Page 20)

PIcon II Manager
Rev 1.0 January 2014 15
MANAGER
Manager Access
Before initializing Manager Mode, restricted programming must be completed. To access PIcon
II Reports and Programming features, a sequence utilizing a valid PIN Code must first be
entered. Access is divided into two categories — Manager and Operator. The manager, using a
Manager PIN Code, has access to Reports and Manager Modes. Reports functions (Modes OPR
1 and OPR 2) are also available to the operator, who uses an Operator PIN Code. Manager
Access is described below.
Entry of the correct Manager PIN Code allows access to all Reports and Manager Modes. First,
press key. The display will prompt for a PIN Code. Enter this PIN Code on the
numeric keypad. (This number, with a maximum of four digits, is stored in the PIcon II. Its
purpose is to limit access to PIcon II program and report data. The number 2422 is the factory
default value for the Manager PIN Code.) Next, press the key. MGR 0 will appear
in the display, prompting entry of the desired function mode number on the numeric keypad.
(See mode descriptions.) Press again to generate the requested program & report
function sequence. At this point, if you wish to return to the operator mode, press the
key to exit from all manager modes.
Manager Accessible Modes
MGR 1 — Program Product Price
MGR 2 — Read Reports (Refer to Reports Section, Read Reports)
MGR 3 — Print Reports (Refer to Reports Section, Print Reports)
MGR 4 — Clear Resettable Totals (Follows in Manager Section)
MGR 5 — Set Date and Time (Follows in Manager Section)
MGR 6 — Beeper Settings (Follows in Manager Section)
MGR 7 — Program Operator/Manager PIN Codes (Follows in Manager Section)
MGR 8 — Shift Report Setup (Follows in Manager Section)
MGR 9 — Set Auto Receipts (Follows in Manager Section)
MGR 10 — Set Default MOP (Follows in Manager Section)