IEI Integration AFL2-17A-H61 v1.11 - Manual (Page 68)

AFL2-17A/AB-H61
P a g e 49
 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
5.3 In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1: Unpack the flat bezel panel PC.
S te p 2: Install the HDD.
S te p 3: Install the K-type temperature sensor.
S te p 4: Install the RFID reader (optional).
S te p 5: Install the CD-ROM (optional).
S te p 6: Configure the system.
S te p 7: Connect peripheral devices to the flat bezel panel PC.
S te p 8: Mount the flat bezel panel PC. S te p 0:
5.4 HDD In s ta lla tio n
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-17A/AB-H61, please follow the steps below:
S te p 1: Remove two (2) retention screws from the HDD cover (Figure 5-1).