IEI Integration AFL2-W21-H61 - Manual (Page 70)

AFL2-W21A/AB-H61
P a g e 51
4.13 Mo u n tin g th e S ys te m
WARNING!
When mounting the flat bezel panel PC onto an arm, onto the wall or onto a
panel, it is better to have more than one person to help with the installation
to make sure the panel PC does not fall down and get damaged.
The four methods of mounting the AFL2-W21A/AB-H61 are listed below.
 Wall mounting
 Panel mounting
 Stand mounting
 Arm mounting
The four mounting methods are described below.
4.13.1 Wa ll Mo u n tin g
To mount the flat bezel panel PC onto the wall, please follow the steps below.
S te p 1: Select the location on the wall for the wall-mounting bracket.
S te p 2: Carefully mark the locations of the four screw holes in the bracket on the wall.
S te p 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
S te p 4: Align the wall-mounting bracket screw holes with the pilot holes.
S te p 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 4-16).