IEI Integration AFL2-W21-H61 - Manual (Page 130)

AFL2-W21A/AB-H61
P a g e 111
S te p 8: Install the new DDR3 memory module by pushing it into the socket at an angle
(Figure 6-4).
S te p 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 6-4).
S te p 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 6-4: DDR SO-DIMM Module Installation
S te p 11: Replace the internal aluminum cover and secure it to the chassis using seven (7)
retention screws.
S te p 12: Replace the back cover and secure it using fifteen (15) previously removed
retention screws.
6.5.2 WLAN Ca rd Re p la c e m e n t
The AFL2-W21A/AB-H61 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
S te p 1: Follow all anti-static procedures. See Section 6.2.
S te p 2: Turn off the power. See Section 6.3.
S te p 3: Remove the back cover. See Section 6.4.1 above.
S te p 4: Remove the internal back cover. See Section 6.4.2 above.