5 k-type temperature sensor installation, Emperature, Ensor – IEI Integration AFL2-W21-H61 User Manual

Page 63: Nstallation, Figure 4-5: securing the hdd

AFL2-W21A/AB-H61

P a g e 44

Figure 4-5: Securing the HDD

S te p 7:

Slide the HDD module back into the device.

S te p 8:

Tighten the captive screw.

S te p 9:

Replace the HDD cover and secure it using two (2) retention screws.

S te p 0:

4.5 K-Typ e Te m p e ra tu re S e n s o r In s ta lla tio n

The AFL2-W21A/AB-H61 has a K-type connector on the external peripheral interface

panel. The K-type connector is connected to a K-type temperature sensor cable. The

K-type temperature sensor cable can be found in the packing list. To connect a K-type

temperature sensor cable to the AFL2-W21A/AB-H61, please follow the instructions

below.

S te p 1:

Locate the K-type connector. The location is shown in Chapter 1.

S te p 2:

Align the connector. Align the K-type temperature sensor cable with the K-type

connector on the AFL2-W21A/AB-H61 . Make sure the orientation of the

connector is correct.