IEI Integration UPC-12AH_GM45 v2.00 - Manual (Page 94)

UPC-12A/GM45 Panel PC
Page 82
Î
Enabled
Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
Î Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
Î
COM1 D EFAULT
System is remotely accessed through COM1
Î
COM2
System is remotely accessed through COM2
Î
COM3 System is remotely accessed through COM3
Î
COM4 System is remotely accessed through COM4
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Î Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Î Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D
EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1
ƒ 19200 8,n,1